Nanotech 2009 Vol. 3
Nanotech 2009 Vol. 3
Nanotechnology 2009: Biofuels, Renewable Energy, Coatings, Fluidics and Compact Modeling

Carbon Nano Structures Chapter 7

Influence of MWNT on the physical properties of polyethylene nanocomposites

Authors: P. Ciambelli, M. Sarno, H.C. Neitzert, M.R. Nobile, E. Somma, O. Valentino

Affilation: University Of Salerno, Italy

Pages: 473 - 476

Keywords: HDPE, carbon nanotubes, electrical and thermal characterization

Physical properties of a series of multi-walled carbon nanotube-high density polyethylene (MWNT-HDPE) composites, prepared by melt mixing in a micro-twin screw extruder, were investigated. The effect of MWNT concentration (0.5-7 wt%) and nanotube surface treatment (oxidative treatment in a tubular furnace at 500°C for 1 - 2 hr in a 95% nitrogen, 5 % oxygen atmosphere) was investigated by several experimental techniques. Scanning electron microscopy showed good adhesion and dispersion of nanotubes in the matrix, independently of the surface treatment. TG analysis suggests that the incorporation of MWNT in the polymer results in increased oxidative stability. Electrical and rheological measurements showed that the oxidative treatment, causing some reduction of the MWNT quality (indicated by Raman Spectroscopy), decreases the efficiency of the nanotube-matrix interaction. Electrical measurements performed under temperature cycles show a narrow window in which the electrical properties improve and then finally fall. The evaluated electrical percolation threshold is in good agreement with rheological percolation threshold. The isothermal quiescent crystallization, studied by rheometric techniques, clearly indicates that increasing the MWNT concentration in the composite the onset of crystallization occurs earlier. Such a behavior confirms the nanotube nucleant effect previously observed by non-isothermal DSC. Finally, flow induced crystallization has been investigated.

ISBN: 978-1-4398-1784-1
Pages: 694
Hardcopy: $179.95